Settings Reset makes all the settings of your PHPoC products to factory default.
A certificate in PHPoC is also deleted.
Settings Reset Procedure
| Step | Action | Product State | STS LED |
|---|---|---|---|
| 1 | Input LOW signal to ISP# shortly (less than 1 second) | Button setup mode | On |
| 2 | Input LOW signal again over 5 seconds | Preparing initialization | Blink very rapidly |
| 3 | Check if the STS LED is turned OFF | Initialization ready | Off |
| 4 | Release the LOW input right after the STS is OFF.(※ If you don't release the button within 2 seconds, the state goes back to the step 3) | Progressing initialization | On |
| 5 | Rebooting automatically | Initial state | Off |
Factory Reset makes all the settings including saved password of your PHPoC products to factory default. Furthermore, all files stored in flash memory are deleted as well as certificate. Because of this, you have to back up your files before doing Factory Reset.