Introduction
PES-2605
PES-2605, stepper motor controller, is a smart expansion board for PHPoC shield for Arduino. You can accurately control various stepper motors with this board via the Arduino sketch.
Highlights of PES-2605
- bi-polar stepper motor controller
- driving modes: micro step(maximum division rate: 1/32)
- motor voltage: 4 ~ 18V [DC]
- motor current: maximum 1A on each coil
※ Caution : Both a PHPoC shield with R2 or later version and an Arduino board are required to use this board!
What is the Smart Expansion Board for PHPoC shield?
A smart expansion board for PHPoC shield has own devices and firmware. This board communicate with a PHPoC shield in a master-slave protocol through the designated port. Two or more smart expansion boards can be connected to one PHPoC shield and each of them required to be setting a slave id.