Set for the First Time

The existing Arduino Ethernet and WIFI shields set IP address and MAC address in the source codes. Unlike those shields, P4S-347-R2 provides a function which manages environment parameters related to the network of the shield itself.

Here is how to set up parameters related to wired/wireless network on PHPoC Shield for Arduino for the first time. A mobile phone or a laptop is required for the settings.

Set for The First Time

  1. Connect the shield to your Arduino.

    connect_to_uno

  2. Input power to the Arduino.

    phpoc_shield_uno_input_dc_1

  3. Insert a USB WIFI dongle to the shield.

    insert_wlan

  4. Push SETUP button on the shield once.

    phpoc_shield_uno_wlan_push_setup

  5. With your mobile(or laptop), connect to the wireless network starting with "phpoc_".

    connect_wlan

  6. Run a web browser once it is properly connected to the wireless LAN.

    web_browsers

  7. Connect to the shield by entering "192.168.0.1" in the address bar.

    web_connect

  8. Move to the SETUP page by clicking the "Setup" image.

    bcfg_main

  9. You can set network, time and web application parameters on this page.

    web_setup_info