• Overview
• Hardware Specifications
• Schematic
• First Use (Web Serial Monitor)
• Connecting to Network
  • Set for the First Time
  • Connecting to an AP
  • Operating as an AP
  • Setting an IP
    • Auto IP Address
    • Static IP Address
  • Verifying the IP Address
• Using Library
  • Library Overview
  • Installing the Library
  • Using the Examples
• Using Embedded Web Applications
  • Web Serial Monitor
  • Web Serial Plotter
  • Web Remote Control(Push)
  • Web Remote Control(Slide)
  • Web Remote Control(Pad)
• Other Settings
  • Setting the Time
  • Settings for Web Apllications

Setting the Time

This shield provides an RTC function for time information. With the built-in battery mounted on the shield, it maintains the time information even when the power is turned off.

Because of the built-in battery charging system, the battery is charged whenever the power is connected to the shield. However, if you do not connect power to shield for a long period (about 30 days in full-charged), the battery is discharged and time information may be initialized.

Setting the Time

1. Connect to the web setup page of shield.

   

2. Move to the SETUP page.

   

3. Click the [TIME SYNC.] on the [TIME] tap.

   

4. Check the [PHPoC Shield Time] is synchronized with the [Host Local Time].