• Overview
• Hardware Specifications
• Schematic
• First Use (Web Serial Monitor)
• Connecting to Network
  • Set for the First Time
  • Connecting to an AP
  • Operating as an AP
  • Connecting to the Ethernet
  • Setting an IP
    • Auto IP Address
    • Static IP Address
  • Verifying the IP Address
• Using Library
  • Library Overview
  • Installing the Library
  • Using the Examples
• Using Embedded Web Applications
  • Web Serial Monitor
  • Web Serial Plotter
  • Web Remote Control(Push)
  • Web Remote Control(Slide)
  • Web Remote Control(Pad)
• Other Settings
  • Setting the Time
  • Settings for Web Apllications

Static IP Address

You can set a static IP address to the shield as follows:

1. Connect to the web setup page of shield

   

2. Move to the SETUP page.

   

3. Click the [NETWORK] > [IPv4] menu.

   

4. Select the [IP Address Type] to [Static IP Address].

   

5. Input an IP address, a Subnet mask, a Gateway IP address and a DNS IP address and click the [SAVE].

   

   The IP address must be unique within the network. If you connect the shield to a public network, please make sure whether IP address is already in use or not. If there is a manager in charge of IP address assignment on your network, we recommend to get assistance from the manager.

6. Once the setup is completed, the web browser will be reconnected to its IP address.