• Introduction
• Dimension
• Schematic
• Layout
• How to Use
  • Class and Functions
  • Settings
  • Receiving Data
  • Sending Data

How to Use

This board can be used by steps as follows.

1. Connect to a PHPoC Shield and an Arduino

It is not possible to use this board alone. Please be sure that connection to a PHPoC Shield and an Arduino.

2. Install Libraries for Arduino

Install PHPoC and PhpocExpansion library via library manager on Arduino IDE. Both libraries are required to use PHPoC shield and this board. Refer to the manual pages below for detail about the libraries.

• PHPoC shield library reference

3. Use Sample Codes

Use sample codes in libraries and examples in this manual.