• Introduction
• Dimension
• Schematic
• Layout
• How to use
  • Commands
  • Settings
    • Communication parameter
    • Counter values
    • Inter frame gap
    • Inter frame delimiter
    • Serial Transmission delay
    • Sending break signal
  • Getting status
    • Communication Parameter
    • Counter values
    • Inter frame gap
    • Inter frame delimiter
    • Transmission delay
    • Received data size
    • Size of receive buffer
    • Free space in send buffer
    • Size of send buffer
  • Receiving data
  • Sending data

How to Use

The steps for using PES-2407 are as follows.

1. Connect to a PHPoC board

PES-2407 cannot be used alone. Be sure to connect to PHPoC board.

2. Install Software (IDE)

PHPoC Debugger is a software which is used for configuring PHPoC products and developing PHPoC script. It is required to install this software on your PC because PES-2407 must be controlled by PHPoC.

• PHPoC Debugger Download Page
• PHPoC Debugger Manual Page

3. Use SPC Library and Sample Codes

The SPC library is for smart expansion boards such as PES-2407. This library makes it easy for you to use smart expansion boards. Refer to the manual page of SPC library for more information.

• SPC Library Manual Page