• Overview
• Hardware Specifications
• Schematic
• First Use (Web Serial Monitor)
• Connecting to Network
  • Set for the First Time
  • Operate shield to AP
  • Connect the shield to the wireless LAN router or AP
  • Connect the shield to the Ethernet
  • Set an IP address
    • Automatical IP setup
    • Manual IP setup
  • Verifying the IP Address
• Take Advantage of the Library
  • Library Overview
  • Installing the Library
  • Using the Examples
• Using Embedded Web Applications
  • Web Serial Monitor
  • Web Remote Control (Push)
  • Web Remote Control (Slide)
• Setting the Time

Connect Shield to the Ethernet

The shield can be connected to the Ethernet if any one of those two conditions are followed:

• If wireless LAN is set to “disable”
• If no USB dongle is connected to the shield.

Connect Shield to the Ethernet

1. Connect LAN cable to the shield without connecting a USB WLAN dongle.

   

2. Check the IP address according to the instructions from Verifying the IP Address.

   

Refer to the Manual IP setup if you want to set the IP address by yourself.