Verify the IP Address

  1. Connect shield to the network according to the instruction from Connecting to Network.

  2. Input power to the Arduino and run the Arduino IDE.

    Arduino IDE

  3. Enter the following code in the Arduino IDE.

    Make Sketch

  4. Upload the entered code on the Arduino.

    Upload Code

  5. Click the serial monitor button of Arduino IDE.

    Serial Monitor

  6. Verify the IP Address appearing on the serial monitor window.

    • When the shield is connected to Ethernet

    Verify IP-Ethernet

    • When the shield is set to AP

    Verify IP-SoftAP

    • When the shield is connected to a WLAN router or AP

    Verify IP-Infrastructure