• Introduction
  • Features
  • Hardware Specifications
  • Dimensions
  • Layout
  • Interfaces
  • Application
• Basic Usage
  • Management Software
    • Connection with a PC
    • Initial Setup and Certificates
    • Firmware Upgrade
  • Reset
• MQTT Usage
  • Preparation
    • File System
    • AT Commands
    • Connecting Devices
  • MQTT Settings
    • Topic and Message Buffer
    • Timeout
    • Connection Flags
    • Connection Payload
    • QoS
  • Connecting to Broker
  • SUBSCRIBE
  • PUBLISH
  • Reading Messages
  • Etc.
    • Reading the Client ID
    • Setting Short Response
• Advanced
  • ATC & MQTT Settings
  • Activating PHPoC Engine
  • Advanced AT Commands

Setting Short Response

You can set short response for AT commands.

Setting short response: +MCO

• Command Format

AT+MCO=<Value>

• An exapmle

at+mco=0
OK
at+mqns
+MQNS:4
OK
at+mco=1
OK
at+mqns
+4
OK