Settings Reset makes all the settings of your PHPoC products to factory default.
Settings Reset Procedure
| Step | Action | Product State | STS LED |
|---|---|---|---|
| 1 | Input LOW signal to ISP# shortly (less than 1 second) | Initialization mode | On |
| 2 | Input LOW signal again over 5 seconds | Preparing initialization | Rapidly blinks |
| 3 | Check if the STS LED is turned OFF | Initialization ready | Off |
| 4 | Release the LOW input right after the STS is OFF.(※ If you don't release the button within 2 seconds, the state goes back to the step 2) | Progressing initialization | On |
| 5 | Rebooting automatically | Initial state | Off |
Device Initialization makes all the settings including saved password of your PHPoC products to factory default. Furthermore, all files stored in flash memory are deleted as well as certificate. Therefore, it is highly recommended to back up the files stored in the product's file system and the certificates before performing device initialization.
※ Refer to the Device Initialization page of PHPoC Debugger's Manual for details.